¶ Toolkit Status Icons
A number of key status states can be found in the bottom left corner of the Toolkit application, when hovering over the icon a text explanation is available. If you click the icon this will navigate to the screen to resolve or investigate the issue.
¶ Individual Status Icons and the Relevant Meanings
¶ No Connection
Application is not linked to the WatchMon supervisor.
¶ Heart-beat blinking
Confirms that the system is linked to WatchMon Supervisor.
¶ WiFi
Connection link via WiFi.
¶ Discharge - Normal
Normal System is OK to discharge at normal/high power mode.
¶ Discharge - Limp
System is in limited power for over-discharge mode.
¶ Discharge - Off
System has disabled discharging.
¶ Charge - Normal
System is OK to recharge at normal/high power mode.
¶ Charge - Limp
System is in limited power mode to suit bypass balancing.
¶ Charge - Off
System has disabled charging.
¶ Charge - Complete
State has reached fully charged and is in idle full mode.
¶ Critical Fault
System has disabled the battery Isolator/Contactor.
¶ Heating On
Control for heating has been triggered.
¶ Cooling On
Control for cooling has been triggered
¶ New Software Available
New software available for download and upgrade
¶ New Firmware Available
New firmware is available for hardware devices/modules found in the system.
¶ USB Powered
Supervisor with 5V supply from USB no supply pins
¶ Auto Balance
Auto balance is running from cell Extra Bypass Mode.
¶ Toolkit Logging
Logging is running from the software app.
¶ Pending Collection of System Settings
System is still collecting configurations.
¶ Device Sync
Configuration Synchronisation Task required - Device Sync needed
¶ Bypass Testing
Bypass testing has not been verified
¶ Charge Heat Relief
Charge heat relief has been evoked. Trigger charging is to be paused until the bypass cools down.
¶ Setup Wizard
Wizard setup has not been run on this supervisor.
¶ Network Test
CellMon Network needs to be verified
¶ Configuration Wizard
The Wizard setup has not been finalised.
¶ Low Supervisor Voltage
Low supervisor voltage has been reported (critical supply) typically less than 9V.
¶ Firmware Update
Firmware mismatch Firmware should be updated
¶ Read Only
Supervisor is set to read-only mode. This may be due to a firmware mismatch.
¶ High-Temperature Alert
High-temperature alerts from cell monitors
¶ High Voltage Alert
High voltage alert from cell monitors
¶ Low Voltage Alert
Low voltage alert from cell monitors
