¶ CellMon Voltage Calibrator
Only available to the cell monitors - LongMon, Blockmon, LeafMon distributed monitors.
Not used for the CellMate-K9 (and other legacy products like WatchMon Plus WM5 / WM7, MultiMon MM8).
Will only offset the existing reported voltage in 10mV increments.
WARNING: We do not advise using this except if advised by Batrium that overriding our calibration may make the cell monitor worse.
¶ To find the CellMon Voltage Calibrator, you can navigate to the screen via the Hardware Menu option and choose the CellMon tab. Editing is only available when in 'Technician' mode.
Click on the "Cellmon Calibrator" option.
¶ Procedure
- Step 1 — Select Cell ID
- Step 2 — Specify the measured voltage that will be reported in future.
- Step 3 — Sync device which will update the cellmon offset with the revised value and resume normal monitoring.
Maximum positive offset allowed 20mV
Maximum negative offset allowed -20mV
Minimum number of readings that the voltage has the same reading repeated before being allowed to run the calibration routine.
¶ Logs files are stored at "My Docs / Batrium / Reports / CellMonCal_[SystemCode].txt"
