¶ USB Driver for the WatchMon Toolkit
Guide for installing USB driver for WatchMon Toolkit.
This screen is accessed via the Tools option on the Menu.
¶ 1. Click USB Driver Install.
¶ 2. Choose the appropriate device.
¶ 3. Select "Yes" to allow Installation to proceed.
¶ 4. Click “Next” to start installing the driver.
¶ 5. Accept and click “Next”.
¶ 6. Click “Finish” to close the window.
¶ 7. Connect your WatchMon hardware to the computer using the USB cable provided in your Starter Kit.
¶ 8. Start the WatchMon Toolkit software.
You can also start it by running the shortcut on your Desktop.
¶ 9. Click on “Connect” to start.
¶ Troubleshooting
When you plug in or replug in the USB cable for the WatchMon, do you hear the typically windows sound to say it has found a new USB device?
¶ Verify if the USB driver is installed.
- Open Windows Settings Devices
- Look to see a Silicon Labs USB to UART bridge.
If not found, check your cables and make sure the drivers have been installed properly.
Note: From Version 2.0 there is a USB-legacy and USB option. WatchMon1 and older firmware versions use USB legacy.