The ability to configure the system remotely is underway. It will be available in future updates.
| System Hardware | Allows users to configure the hardware system settings of the Batrium BMS |
| Cell Monitor Hardware | Allows users to configure the hardware CellMon CMU (Cell Monitoring Unit) settings |
| Shunt Hardware | Allows users to configure the hardware Shunt State of Charge settings |
| Expansion Hardware | Allows users to configure the hardware expansion settings. This is where the inputs and outputs are defined. |
| Integration Hardware | Allows users to configure the hardware integration settings |
| Critical Control | Allows users to configure the Critical Battery OK Control Logic settings |
| Charge Control | Allows users to configure the Charging Control Logic settings |
| Discharge Control | Allows users to configure the Discharge Control Logic settings |
| Thermal Control | Allows users to configure the Thermal (heating/cooling) Control Logic settings |
| Remote Control | Allows users to configure the targets transmitted to the remote/external equipment (charger/inverter) |
| SoC% Limits Control | Allows users to configure the SOC% Control Logic settings |
¶ Volt & Temp Guide View
The Volt and Temp Guide is available on applicable configuration screens.
Available on the web app only.
This screen guide allows you to view the cell volt and temperature:
| Cell values in white are | |
| Cell values in red are | |
| Cell values in blue are | |
| Cell values in green are | |
| Cell values in violet are |
¶ Status Definitions for VoltView:
| CMU Alert High (CV11) | Cell voltage alert when above will flash a RED LED on CellMon. |
| Charge Cutout (CV10) | Cell voltage threshold to charge up to, if above will stop when enabled to monitor. |
| Bypass Threshold (CV9) | Bypass Cell Voltage, when above will bypass/bleed power from the cell. |
| Charge Resume (CV8) | Cell voltage to resume / recover the charging process once the actuals have dropped below the threshold specified. |
| Nominal (CV7) | Nominal Cell Voltage for battery chemistry, info only. |
| LimPower Dischg (CV6) |
Cell voltage that when below will put the system into limited power mode; signals to remove non-critical loads or run in limp mode for discharge Only available with Limited Power enabled |
| LimPower Charge (CV5) | Cell voltage that when below will hold the charging process in a limited power state until the system recharges above this threshold. |
| Discharge Resume (CV4) | Cell voltage that is above will resume / restart the discharging process state when monitoring is enabled. |
| Discharge Cutout (CV3) | Cell voltage that is below will stop the discharging process state when monitoring is enabled. |
| CMU Alert Low (CV2) | Cell voltage alert when below will flash the RED LED on CellMon. |
| Critical Low (CV1) | Cell voltage threshold that is OK to operate, if below will change state when monitoring is enabled, the output is connected to the Critical Contactor. |